COBHAM SAILOR 6222 Specifications download pdf (Page 5)

www.cobham.com

Subject to change without further notice.

SAILOR® 6300 MF/HF

For when it really counts

DSC WATCH RECEIVER

Frequency range Scanning: 2187.5 KHz, 4207.5 kHz,

6312.0 KHz, 8414.5 kHz,

12577.0 KHz, 16804.5 kHz

Aerial impedance 50Ω Complies with ETSI 300-373 or better.

ANTENNA TUNING UNIT

Frequency range 1.6 MHz - 27.5 MHz

Aerial requirements 8-18 m wire and/or whip aerial

Aerial tuning Fully automatic with no presetting

Tuning speed 0.1 - 8 sec Typical

Power capability 150W/250W: 330W PEP in 50Ω

500W: 600W PEP in 50Ω

DIMENSIONS AND WEIGHT

150W/250W 500W

Transceiver Unit Width: 392 mm (15.4”) 392 mm (15.4”)

Height: 445 mm (17.5”) 507 mm (20”)

Depth: 127 mm (5”) 217 mm (5”)

Weight: 19 Kg (41.9 lbs) 28 Kg (61.7”)

Antenna Tuning Unit Width: 290 mm (11.4”) 401 mm (15.3”)

Height: 500 mm (19.7”) 617 mm (24.3”)

Depth: 80 mm (3.1”) 356 mm (14”)

Weight: 3.3 Kg (7.3 lbs) 17 mm (37.5”)

Control Unit Width: 240 mm (9.5”) 240 mm (9.5”)

Height: 105 mm (4.1”) 105mm (4.1”)

Depth: 100 mm (3.7”) 100mm (3.7”)

Weight: 3.3 Kg (7.3 lbs) 3.3 Kg (7.3 lbs)

SPECIFICATIONS

Operating Modes Simplex and semi-duplex SSB telephony

and DSC, TELEX AM broadcast reception

Operating temperature range -15°C to +55°C

Supply voltage Nominal 24V DC floating

With optional external AC power supply:

115/230V AC 50/60 Hz. Automatic changeover

to DC in the absence of AC supply

Power consumption Rx, 60W (approx. at 24V DC)

150W 250W 500W

Tx, SSB speech: 175W 300W 600W

Tx, SSB two-tone: 300W 550W 1100W

Tx, DSC/TELEX: 420W 600W 1000W

User-programmable channels 199 frequency pairs with mode (1-199)

User-programmable stations 40 stations with name, MMSI and station channel

RECEIVER

Frequency range 150 kHz to 30 MHz

Aerial impedance 50Ω automatically matched by the aerial tuning unit

Sensitivity Aerial input for 10 dB SINAD, 50Ω aerial:

SSB tel.: 0.7 µV

AM tel.: 4 µV

DSC/Telex: 0.7 µV

Complies with ETSI 300-373 / 300 338.

Audio output power 6W with less than 10% distortion

TRANSMITTER

Output power 150W PEP +/-1.4 dB into 50Ω voice.

Reduction to 80W when continuously keyed single

tone, with duty cycle greater than 55% during 1 min.

Automatic power recovery after 1 min.

250W PEP +/-1.4 dB into 50Ω voice.

Reduction to 100W when continuously keyed single

tone, with duty cycle greater than 55% during 1 min.

Automatic power recovery after 1 min.

500W 1.6 to 3.999 MHz 400W PEP +0/-1,4 dB into

50Ω voice. 4.0 to 29.999 MHz 500W PEP +/- into

50Ω voice. 3 dB reduction when continuously keyed

single tone, with duty cycle greater than 55% during

1 min. Automatic power recover after 1 min.

Power reduction Low approx.: 10W

Frequency range ITU marine bands from 1605 kHz to 30 MHz

DSC-TELEX MODEM

DSC Equipment class Class A

Protocols DSC: ITU-R M. 493-13, and M. 541-6

Telex: ITU-R M. 625-2 (incl. M. 476-4), M. 490,

M. 491-1, and 492-5

NBDP telex in ARQ, FEC and SEL FEC modes

Ship’s identity DSC: 9-digit identity number

Telex: 5- and/or 9-digit identity numbers

Interfaces Alarm: DSC distress alarm interface

NMEA: NMEA 0183 interface for GPS equipment

Industrial ethernet Line, Key: Transceiver AF line

input/output and external key interface. -10 to +10

dBm, 600Ω

AUX alarm 2: Telex and non-distress/urgency

DSC alarm output

ThraneLINK

ThraneLINK is a sophisticated communication protocol that con-

nects the SAILOR products in a network, offering important new

opportunities to vessels. It provides facility for remote diagnos-

tics and enables access to all the SAILOR products from a single

point for service. This results in optimized maintenance and

lower cost of ownership because less time is needed for trouble-

shooting and service. Installation is made easier as ThraneLINK

automatically identifies new products in the system. The uniform

protocol is an open standard which provides a future proof solu-

tion for all vessels.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Comments to this Manuals

No comments

COBHAM SAILOR 6222 Specifications Page 5

Comments to this Manuals